Glass and first cockpit cleats

After sanding the fillets and cleaning up, I put down glass between floor 6 and bulkhead 7 on both sides. The other major job for today was to make up the two cleats along the side panels for the cockpit. It took quite some time planing the top face to square it up against the bulkheads and to get the ends to sit properly. The bottom edge is, of course, rounded over. The cleats are not glued in as yet. I will spend another few minutes to triple check that things line up, that is that the tops of the cleats and the tops of the bulkheads are all in one plane.